We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy.
Unfortunately, activation email could not send to your email. Please try again.
Syncfusion Feedback

Install on Win10 x64 + VS 2013 + Dashboard

Thread ID:

Created:

Updated:

Platform:

Replies:

121937 Feb 9,2016 07:33 PM UTC Feb 15,2016 03:24 PM UTC General Discussion 3
loading
Tags: General Discussion
Ricardo
Asked On February 9, 2016 07:33 PM UTC

Hi there
After installing full Dashboard, Visual Studio 2013 didn't work. I need to start as Administrator and run for many minutes loading Essential Studios dll's:

"Adding toolbox items from assembly 'xxxx.dll'

Thanks
Ricardo


Manivannan Sundararajan [Syncfusion]
Replied On February 10, 2016 01:22 PM UTC

Hi Ricardo,

We are sorry for the inconvenience.

Initially Visual Studio takes some minutes for loading all the configured assemblies(Syncfusion assemblies and if any other controls configured) in Visual Studio toolbox based on machine configuration. It will not load each time when opening the Visual Studio.

While loading the controls, you can’t access the Visual Studio. Please wait until the Visual Studio loads the Syncfusion controls in Visual Studio toolbox. Once the controls has been loaded successfully, you can use the Visual Studio for development.

Regards,
Manivannan S.

Ricardo
Replied On February 13, 2016 11:50 AM UTC

Thanks - it worked but took many minutes (and I have a i7...) - if this could be done in another way (faster...) was the best

Kathiresan Subramaniam [Syncfusion]
Replied On February 15, 2016 03:24 PM UTC

Hi Ricardo,

Toolbox getting delay to initialize in Visual Studio due to removal of .tbd files and reconfigure. For the first time it will take some time to configure toolbox in Visual Studio and creating .tbd files. If once it is configured, then next time onwards toolbox will be loaded faster.

This much of time taken due to the total count of controls to be configured in Visual Studio such as Microsoft controls, Syncfusion controls and other installed setup (If you have). So that toolbox initialization taking this much of time to configure.

Also, we will better to configure our controls in Visual Studio. Could you share about time taken to configure in Visual Studio?

Regards,
Kathiresan S.

CONFIRMATION

This post will be permanently deleted. Are you sure you want to continue?

Sorry, An error occured while processing your request. Please try again later.

Warning Icon You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.Close Icon

;