Separated connectors become merged after saving and restoring from xaml file.

[Vadzim Shchahlou]

Hello!
I tried to draw 3 parallel connectors between 2 nodes. I used DockPorts. Later I saved the diagram and restored the diagram from xaml. My connectors were not parallel, they had common beggining. Can I prevent this behavior and restore connector how they were saved?

[Ranjitha Amirthalingam]

Hi Vadzim, 

 

Connectors created from the Dockport are serialized and deserialized properly in our end. We could not able to reproduce the reported issue. We have provided sample and video to represent this. Please refer to them as below. 

 

Sample Link: https://www.syncfusion.com/downloads/support/directtrac/general/ze/Create_Connector-1736107961.zip 

 

Video Link: https://www.syncfusion.com/downloads/support/directtrac/general/ze/Dockport_video-1324320141.zip 

 

If the scenario represented in the video is different from the reported issue. Please replicate the issue in the provided sample. Also, please let us know your product(SfDiagram) version. This helps us to serve you better. 

 

Regards, 

Ranjitha A.