We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy. Image for the cookie policy date

Connector Label Positioning when Connector Re-Routed

Hi,

Watch the attached video.
The label on the green connector was created by double-clicking after the connector was dropped.
I have specified relativeMode: 'segmentpath' in the textChange event handler.
The label on the red connector was added the same way, except it was subsequently dragged to the position shown at the start of the video.

Re-routing the green connector causes the label to move, and I understand that - at least it stays on a segment.

As you can see, re-routing the red connector has undesirable results.
Is there any way to keep this connector's label where it was manually dragged?

Thanks for any advice.

Jim

Attachment: Syncfusion__Connector_Label_Challenge__22mar2017_7269dd0a.zip

1 Reply

SG Shyam G Syncfusion Team March 24, 2017 05:38 AM UTC

Hi Jim, 

We considered this “Need to provide support to update label position based on nearest offset while dragging the label from node/connector” as an feature and a support incident has been created under your account to track the status of this requirement. Please log on to our support website to check for further updates. 
 

Regards, 
Shyam G 


Loader.
Up arrow icon