OrgLine Link change the route and bending direction

[Tagir]

Hello support!

 I'm trying to connect two rectangles in a diagram builder with a OrgLine link.

I need to connect right side of first node with left side of second node.

The connector is bended first down then right then down again and as you can see in the attached screenshot it does not look good.

I need it to got straight to the right first then down then right again to meet the second rectangle.

Can you please let me know how I can change that default behaviour?

Thank you

Tagir

Attachment: orgline_link_e6291bfa.zip

[Ashok Kumar V]

Hi Tagir,

Thanks for your interest in Syncfusion product.

We have analysed the reported problem and we suspect this could be an issue. Please create an incident on behalf of this reported problem from the following link for better assistance.

Here is the link: link

Please let us know if you have any concerns.

Regards,

Ashok Kumar.