Visual Studio crashes wuhen editing RibbonControlAdv Form

[Carlos Ferreira]

Hello,

When a Form contains a RibbonControlAdv and on edit mode, try to close the window, the Visual Studio crashes and restarts. It's almost impossible to delete the form or close the form without Visual Studio restarts over and over again...

Using Visual Studio 2019 Community.

Using Winforms 18.2.044 assemblies.

[Vijayalakshmi Roopkumar]

Hi Carlos,    

   

Thanks for your contacting Syncfusion Support.  

  

The reported behavior “Visual Studio crashed when closing the ribbon form in designer” has been fixed internally at our end. We have taken the patch for the same and it can be downloaded from following location: 

 

 

Recommended approach - exe will perform automatic configuration.   

   

Please find the patch setup from below location:   

http://syncfusion.com/Installs/support/patch/18.2.0.44/1085885/F157263/SyncfusionPatch_18.2.0.44_1085885_8262020023912067_F157263.exe 

 

   

Patch link :    

Please find the patch assemblies alone from below location:   

   

Assemblies Link:   http://syncfusion.com/Installs/support/patch/18.2.0.44/1085885/F157263/SyncfusionPatch_18.2.0.44_1085885_8262020023912067_F157263.zip 

 

  

Nuget link:     

http://syncfusion.com/Installs/support/patch/18.2.0.44/1085885/F157263/SyncfusionNuget_18.2.0.44_1085885_8262020023912067_F157263.zip 

  

Feedback: https://www.syncfusion.com/feedback/16261/ribbon-control-takes-more-memory-when-an-item-is-added-to-qat-at-runtime     

 

Assembly Version: 18.2.0.44   

   

Installation Directions:   

This patch should replace the files "Syncfusion.Tools.Windows” under the following folder.   

$system drive:\ Files\Syncfusion\Essential Studio\$Version # \precompiledassemblies\$Version#\[TargetFramework]   

Eg : $system drive:\Program Files\Syncfusion\Essential Studio\18.2.0.44\precompiledassemblies\18.2.0.44\4.6   

   

To automatically run the Assembly Manager, please check the Run assembly manager checkbox option while installing the patch. If this option is unchecked, the patch will replace the assemblies in precompiled assemblies’ folder only. Then, you must manually copy and paste them to the preferred location or you must run the Syncfusion Assembly Manager application (available from the Syncfusion Dashboard, installed as a shortcut in the Application menu) to re-install assemblies.   

   

https://www.syncfusion.com/support/directtrac/patches   

   

Disclaimer:   

Please note that we have created this patch for version 18.2.0.44 specifically to resolve the issue reported in this incident. If you have received other patches for the same version for other products, please apply all patches in the order received.  Please let us know, if you are using any other Syncfusion version, we will provide patch in your version.   

   

Regards,   

Vijayalakshmi VR