Controls are not working when using ErrorProvider in a GGC

[Meganathan Malli Viswanathan]

Hi,

I am using ErrorProvider in a GGC, when user some invalid value in the cell it gives a warning meesage in that particular cell. At this poing none of the control eroking. For ex. if the user provided with a ccanel button it is not working.

[Meganathan Malli Viswanathan]

>Hi,

I am using ErrorProvider in a GGC, when user provides some invalid value in the cell it gives a warning meesage in that particular cell. Here none of the controls are working which are available in that form. For ex. if the user provided with a cacnel button it is not working. The UI is getting frozed until the user responds with a correct value or press Esc key.

[Rajadurai C]

Hi Meganathan,

Thanks for your interest in Syncfusion products.

It is a general behavior for an ErrorProvider control to popup messagebox on entering invalid value in a cell. Until the valid value is entered in the cell, the focus cannot leave that particular record to any other record in GGC or other control.

Regards,
Rajadurai