We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy.
Unfortunately, activation email could not send to your email. Please try again.

Assembly problem very urgent

Thread ID:





64488 Jul 21,2007 02:29 AM Jul 23,2007 05:49 PM General Discussion 1
Tags: General Discussion
Janesh Hari
Asked On July 21, 2007 02:29 AM

While am switching from one form to another, am getting error and i think its a assembly error.
the project is already done 2 years before the version was v1.1.4322

Now my client is getting the debugg error while switching from one form to another.

I searched it and found that its because of syncfusion controls..

When switching from one form the controls are gets disposed.. the issue is at that point.

Please give me a a solution. what can i do.

Ramu [Syncfusion]
Replied On July 23, 2007 05:49 PM

Hi Janesh,

Please have a look at the KB article and let me know if you have any queries.


This gives you the details about switching between the versions.

If this doesn’t solve your issue, Could you let me know the two versions you used to switch?

We will provide you some more information to solve your issue.



This post will be permanently deleted. Are you sure you want to continue?

Sorry, An error occured while processing your request. Please try again later.

You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.