SFRange Slider Issue with Corner radius on the Start position along with TrackSelectionColor

[Bryan Garcia]

Hi team,

I am using the SFRange slider as a single slider. And I added the TrackSelectionColor and the Corner radius. 

I can see the Corner radius on the Max end, but the starting track has the Square edges(check the screenshot below). When I set the TrackSelectionColor to transparent I can see the rounded corner on both sides. 

Can you help me to achieve rounded corners on both sides with TrackSelectionColor ? 

[Vijayakumar Viswanathan]

Hi Bryan,

We were able to reproduce the reported issue “ SFRange Slider Issue with Corner radius on the Start position along with TrackSelectionColor ” and we have confirmed this as a bug and logged a defect report. You can track the status of the bug from the below link.

Link: Corner Radius was not applied to the slider track when TrackSelectionColor was applied in Xamarin.Forms | Feedback Portal (syncfusion.com)

We will provide a patch for this issue on September 6, 2022. We appreciate your patience until then.

Note: The provided feedback link is private, and you need to log in to view this feedback.

If you have any more specifications/precise replication procedures or a scenario to be tested, you can add them as a comment in the portal.

Regards,

Vijayakumar V

[Vijayakumar Viswanathan]

Hi Bryan,

 

We have fixed the “SfRange Slider Issue with Corner radius on the Start position along with TrackSelectionColor ”. Please find the fixed assembly files in the attachment.

 

Assembly version: 20.2.0.46

 

Please note that we have created these assemblies for version 20.2.0.46 specifically, to resolve the issue reported in this ticket. If you have received other patches for the same version for other products, please apply all patches in the order received.

 

Note: Please refer to the below link to apply the custom assembly

 

https://www.syncfusion.com/kb/8279/how-to-apply-the-custom-assemblies-when-configured-the-project-with-syncfusion-nuget

 

This fix will be included in our upcoming weekly release. We appreciate your patience until then.

 

Disclaimer: Inclusion of this solution in the weekly release may change due to other factors, including but not limited to QA checks and work reprioritization.

Attachment: AssemblyFile_50940212.zip