Circular gauge two way binding on drag event

Question

Hi,is there any way to update bindable property in viewmodel via pointer drag event?I have not been able to do it by setting binding mode explicitly to two way.Thank you.

Sri Gayathri Gopalakrishnan · Answer

Hi Rjeremy, 
 
Query: Circular gauge two-way binding on drag event 
 
We have prepared sample based on your scenario, in which ViewModel property has been binded to NeedlePointer Value property. While dragging the needle pointer, pointer value doesn’t update. Could you please confirm whether the above issue you have faced? If so, we have considered this as defect and logged defect report. This fix will be included in our Volume 2 sp1 release which is expected to be rolled out by the end of June 2018.If the above case is not your scenario, please elaborate problem with replication steps or modify the given sample. Please download the sample from the below link, 
 
http://www.syncfusion.com/downloads/support/forum/137785/ze/CircularGaugeTest-2138826912  
 
Regards, 
Sri Gayathri. G

rjeremy · Answer

Hi, Sri Gayathri.Yes, that is exactly the same issue.Thank you very much for your support.

Sri Gayathri Gopalakrishnan · Answer

Hi Rjeremy,  
 
Thanks for the update.  
 
As per our previous update, the reported query “While dragging the needle pointer, pointer value doesn’t update” will be fixed and included in our Volume 2 sp1 release which is expected to be rolled out by the end of June 2018. We appreciate your patience until then. 
 
Regards, 
Sri Gayathri. G