Hi Brij,
Thank you for contacting Syncfusion Support.
This reported behavior may occur when application reference assembly version is not common. So Essential studio and Framework version of added assembly needs to be common and the specific version needs to be set as False. Please see the below screen shot and ensure this at your end.
Follow the below steps.
· Close the application.
· Delete Bin and Obj folders in application.
· Reopen the application.
· Rebuild your project.
· Check once again to see whether the project refers to the Syncfusion assemblies of installed version and try the same.
If the issue continues, confirm whether you have referred the assemblies from GAC or any local reference and if more than one Syncfusion Essential studio setup is installed. This will be helpful to analyze and provide prompt solution as earlier as possible.
Regards,
Vinothini.R
