Connect to edge of port instead of center

[David Little]

I'm working from a solution posted by customer service at http://www.syncfusion.com/forums/117649/port-label. As is seen in the attached image, the connectors are linking to the center of the port. Is it possible to offset the connector so it is linked at the edge? 

Attachment: 1162015_23550_PM_a75791b1.zip

[Sundar Stalin]

Hi David,

Requirement: Connect to Edge/Circumference of ConnectionPort instead of center

We have considered your requirement as Feature request. So, we have created a new incident (#134206) under your Direct-Trac account to have a follow up with the requested feature. We would request to follow that incident for further technical support.

Please let us know if you require further assistance on this.

Regards,

Sundar S.