How to Control Line Routing?

[Youngjin Kim]

Hi...

I connected several rectangles with orthogonal connector.
The property LineRoutingEnabled of diagram model and every connectors in diagram was set to true.
When I begin to move a rectangle, the connectors near the moving rectangle automatically reroutes.

I would like to know is "When I move a rectangle, how to make connectors only connected the moving rectangle can reroute?"

The process is like this.
1) If I connect two rectangles with a connector, it will be routed automatically and after connected both ends it stops routing automatically.
2) If I move rectangle near the connector created step 1) should not reroute but connector connected this moving rectangle should reroutes again.

In other words, I would like to make connector's automatic routing action is in effect only when it's connected rectangles are moving.

Regards,

Youngjin Kim

[Amsath Ali M]

Hi Youngjin,

Thanks for your interest in Syncfusion products.

We are glad to inform that we have created a simple sample to achieve your requirements and the same can be downloaded from the below link.

forum-control line routing-537325687.zip

Kindly try the above sample and let us know if you have any queries.


Regards,
Amsath Ali. M

[Youngjin Kim]

Hi...

Thanks for the reply.

The sample that I received was very helpful and it really cleared my problem.

Regards,

Youngjin Kim

[Amsath Ali M]

Hi Youngjin,

Thanks for the update.

We are happy to hear that the issue has been resolved.

Please let us know if you need any further assistance.


Regards,
Amsath Ali. M