Articles in this section
Category / Section

How to install and remove Syncfusion Essential Studio assemblies from GAC ?

1 min read

Installing assemblies in GAC

 

While installing the Syncfusion installer, “Register Syncfusion assemblies in GAC” check box will be enabled by default.

Installing Syncfusion Setup - Assemblies in GAC

If you have installed by enabling the checkbox, Syncfusion assemblies will be installed in GAC location.

If you have installed the by disabling this checkbox, you can install assemblies in GAC using Syncfusion Assembly Manager Utility after installation. Refer the following documentation link for more information about Syncfusion Assembly Manager.

https://help.syncfusion.com/common/essential-studio/utilities#assembly-manager

Removing assemblies from GAC

While installing the Syncfusion installer, Uninstall the previously installed assemblies from GAC” checkbox will be enabled by default. This will remove the previous version Syncfusion assemblies only from GAC. If you need older version Syncfusion assemblies in GAC, you can disable this checkbox and install the Syncfusion installer.

 

Removing assemblies from GAC

You can also install/remove the specific version assemblies in GAC using Syncfusion Assembly Manager Utility. Refer the above Assembly Manager Documentation link for more information.

Did you find this information helpful?
Yes
No
Help us improve this page
Please provide feedback or comments
Comments
Please sign in to leave a comment
Access denied
Access denied