We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy. (Last updated on: November 16, 2018).
Unfortunately, activation email could not send to your email. Please try again.
Syncfusion Feedback

how to customize the Selection behavior of Nodes and Connectors

Platform: UWP |
Control: SfDiagram |
Published Date: February 22, 2017 |
Last Revised Date: February 22, 2017

We have a support to customize the Selection behavior of Nodes and Connectors. This can be achieved by override the PointerSelection method of SfDiagram. This method to decide whether the selection should be done in PointerDown. In that, the Selection method is used to select/Deselect the Node and Connector in PointerDown Event. The ClearSelection method is used to clear the selection when the argument source became a SfDiagram. We have provided code example to represent this.

Please refer to the code example as below.

C#

 

 

2X faster development

The ultimate UWP UI toolkit to boost your development speed.
ADD COMMENT
You must log in to leave a comment

Please sign in to access our KB

This page will automatically be redirected to the sign-in page in 10 seconds.

Up arrow icon

Warning Icon You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.Close Icon