We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy. (Last updated on: November 16, 2018).
Unfortunately, activation email could not send to your email. Please try again.
Syncfusion Feedback

How to customize the direction of Bridge

Line Bridging creates a bridge for lines to smartly cross over other lines, at points of intersection. By default, the Connector with the higher z-order (upper one) draws an arc over the underlying connector when two line connectors meet each other. We have provided support to change the direction of Bridge (which connector will have a Bridge) by using BridgeDirection property. Bridging can be enabled/disabled either with the Connector.Constraints or diagram.Constraints. We have provided code example and screenshot to represent this. Please refer to the code example and screenshot as below.

C#:

 

Screenshot:
Article ID: Published Date: Last Revised Date: Platform: Control:
6450 03/03/2016 03/03/2016 WinRT SfDiagram
Did you find this information helpful?
Add Comment
You must log in to leave a comment

Please sign in to access our KB

or the page will be automatically redirected to sign-in page in 10 seconds.

Warning Icon You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.Close Icon