We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy. (Last updated on: November 16, 2018).
Unfortunately, activation email could not send to your email. Please try again.
Syncfusion Feedback

How to use multiple Needle in Radial Gauge?

You can use the multiple Needle by using the property named EnableCustomNeedles in RadialGauge. This requirement can be achieved by following the below steps.


  1. Need to initialize the Needle by using the class named “Needle” in RadialGauge.
  2. Need to add required Needle to NeedleCollection in RadialGauge.


The following code example demonstrates the same.





Figure 1. Before enabling the EnableCustomNeedles property in RadialGauge.

Figure 2. After enabling the EnableCustomNeedles property in RadialGauge.

See also: How to enable multiple needles in Radial Gauge

Sample Links:

C#: RadialGauge_MultipleNeedle_C#

VB: RadialGauge_MultipleNeedle_VB

Article ID: Published Date: Last Revised Date: Platform: Control:
5746 11/20/2015 11/20/2015 WinForms RadialGauge
Did you find this information helpful?
Add Comment
You must log in to leave a comment

Please sign in to access our KB

or the page will be automatically redirected to sign-in page in 10 seconds.

Warning Icon You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.Close Icon