We use cookies to give you the best experience on our website. If you continue to browse, then you agree to our privacy policy and cookie policy.
Unfortunately, activation email could not send to your email. Please try again.

Reconfiguring the toolbox from Dashboard

 

Before reconfiguring the toolbox, please ensure that the necessary Syncfusion framework assemblies are installed on your machine.

Follow the link below to find the Syncfusion assemblies:

[Syncfusion Installed Path]\assemblies\2.0 or 3.5 or 4.0 folders

Note: Before reconfiguring the toolbox, you need to close all Visual Studio applications.

Follow the below steps to reconfigure the toolbox:

·       Open the Dashboard from either of these locations:

Start -> Programs ->Syncfusion -> Essential Studio x.x.x.x -> Dashboard

-or-

[Syncfusion Installed Path]\infrastructure\Dashboard\2.0 or 3.5 or 4.0 folder

·       The Visual Studio .NET toolbox can be reconfigured under Toolbox Configuration in the Dashboard.

 

    The following options are available under Toolbox Configuration:

·       Install VS2005 - Configures Framework 2.0 Syncfusion controls in the VS 2005 toolbox.

·       Install VS2008 - Configures Framework 3.5 Syncfusion controls in the VS 2008 toolbox.

·       Install VS2010 - Configures Framework 4.0 Syncfusion controls in the VS 2010 toolbox.

·       Install VS2005 Controls in VS2008 - Configures Framework 2.0 Syncfusion controls in the VS 2008 toolbox.

·       Install VS2005 Controls in VS2010 - Configures Framework 2.0 Syncfusion controls in the VS 2010 toolbox.

·       Install VS2008 Controls in VS2010 - Configures Framework 3.5 Syncfusion controls in the VS 2010 toolbox.

If you receive an error message stating that "[Syncfusion Installed Path]\assemblies\2.0 or 3.5 or 4.0 does not have any assemblies to configure," follow the steps listed below:

Note: If the Framework check box is grayed out in the Assembly Manager, please view this KB article to resolve this issue:

Framework check box is grayed out in the Assembly Manager

·       Run the Syncfusion Assembly Manager to install the Syncfusion assemblies into the GAC and also in the assemblies folder.

·       Then reconfigure the corresponding framework version assemblies in the Visual Studio toolbox.

 You can view detailed documentation about toolbox reconfiguration in the below link:

Toolbox Configuration

Article ID: Published Date: Last Revised Date: Platform: Control:
2141 04/30/2011 07/10/2014 Miscellaneous Install and Configuration
Did you find this information helpful?
Add Comment
You must log in to leave a comment

You are using an outdated version of Internet Explorer that may not display all features of this and other websites. Upgrade to Internet Explorer 8 or newer for a better experience.